XW E-Panel installation manual Rev: A Page 1 of 11 14000 Burn Rd Arlington, WA 98223 USA Ph (425)374-9060 www.midnitesolar.com Model MNE250XW The MidNite Solar XW E-Panel is … … for a single XW inverter installation. Use this installation manual to aid in installation. The installation of an electrical system such as this fall under the guidelines of the NEC in the USA. Canadian electrical codes have jurisdiction in Canada. These instructions are not intended to be used in lieu of these local and federal codes, but …

Model MNE250XW The MidNite Solar XW E-Panel is designed for a single XW inverter installation. Use this installation manual to aid in installation. The installation of an electrical system such as this fall under the guidelines of the NEC in the USA. Canadian electrical codes have jurisdiction in Canada. These instructions are not intended to be used in lieu of these local and federal codes, but rather are used as specific to this product. You may need to consult with a professional Solar installer or electrical inspector when in doubt on code specific questions and system installation issues. Even though the E-Panel incorporates and simplifies numerous separate electrical circuits into one enclosure, an inverter system such as this is still a very sophisticated and somewhat complicated electrical system. The XW inverter should be mounted to the wall prior to installing the E-Panel. Pay attention to the total height of the system. Refer to the dimensioned drawing on page 2. Installing the E-Panel to the inverter: To install the E-Panel, remove the door and deadfront. Attach top and bottom wall mounting brackets to the E-Panel using four M6 x 10mm taptite XW E-Panel installation manual Rev: A Page 2 of 11 screws supplied. The top mounting bracket slides up behind the inverter to space the inverter out the proper distance from the wall. The top mounting bracket does not screw to the wall, but rather just acts as a spacer. Refer to pictures on page 2 for bracket placement. Dimensions of XW E-Panel and inverter Top left Top right Bottom left Bottom right Each mounting bracket is held on using two 6mm x 10mm thread forming screws. Use a #3 Philips screwdriver for these four screws…. XW E-Panel installation manual Rev: A Page 4 of 11 Installing the E-Panel to the inverter continued: Remove two 5mm #2 Philips tip screws from the bottom of the inverter that will be used to attach the E-Panel. These two screws are the only attachment to the inverter. The bottom wall mounting bracket also needs to be secured to the wall. You must also remove the battery terminal bolts prior to setting the E-Panel in place. Note: 10-32 UNF screws are interchangeable with the 5mm screws if you should misplace them.

Download XW E-Panel installation manual.Pdf