keep this operation manual for future reference fujitsu general limited operating manual p/n9315345011-01 indoor unit asta … reverse cycle) room air conditioner wall mounted type r410a … KEEP THIS OPERATION MANUAL FOR FUTURE REFERENCE FUJITSU GENERAL LIMITED OPERATING MANUAL P/N9315345011-01 Indoor Unit ASTA 24LCC ASTA 30LCC Outdoor Unit AOTR24LCC AOTR30LCT HEAT & COOL MODEL(REVERSE CYCLE) ROOM AIR CONDITIONER WALL MOUNTED TYPE R410A REFRIGERANT This Air Conditioner contains and operates with refrigerant R410A and Polyol Ester oil.

4 Fig. 6 Remote Control Unit J SLEEP button K MASTER CONTROL button L SET TEMP. button ( / ) M COIL DRY button N Signal Transmitter O TIMER MODE button P TIMER SET ( / ) button Q FAN CONTROL button R START/STOP button S SET button (Vertical) T SET button (Horizontal) U SWING button V RESET button W TEST RUN button ?This button is used when installing the conditioner, and should not be used under normal conditions, as it will cause the air conditioner’s thermostat function to operate incorrectly. ?If this button is pressed during normal operation, the unit will switch to test operation mode, and the Indoor Unit’s OPERATION Indicator Lamp and TIMER Indicator Lamp will begin to flash simultaneously. ?To stop the test operation mode, press the START/STOP button to stop the air condi- tioner. X CLOCK ADJUST button Y Remote Control Unit Display (Fig. 7) Z Transmit Indicator [ Clock Display \ Operating Mode Display ] Timer Mode Display ` Fan Speed Display aTemperature SET Display b COIL DRY Display c SLEEP Display d SWING Display NAME OF PARTS Fig. 1 Indoor Unit 1 Operating Control Panel (Fig. 2) 2 MANUAL AUTO button ? When kept on pressing the MANUAL AUTO button for more than 10 seconds, the forced cooling operation will start. ? The forced cooling operation is used at the time of installation. Only for authorized service personnel’s use. ? When the forced cooling operation starts by any chance, press the START/STOP button to stop the operation. 3 Indicator (Fig. 3) 4 Remote Control Signal Receiver 5 OPERATION Indicator Lamp (red) 6 TIMER Indicator Lamp (green) ? If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page 15 Auto Restart). 7 COIL DRY Indicator Lamp (orange) 8 Intake Grille (Fig. 4) 9 Front Panel 0 Air Filter AAir Flow Direction Louver B Power Diffuser C Right-Left Louver (behind Air Flow Direction Louver) D Drain Hose E Air Cleaning Filter Fig. 5 Outdoor Unit F Intake Port G Outlet Port H Pipe Unit I Drain port (bottom)

Download Fujitsu R410A Operating Manual.Pdf